ZAMP FIA Z20 visor Prism Blue

74,95

ZAMP FIA Z20 visor Prism Blue

The visors of the Zamp Z-20 series are designed to fit all helmets of the Zamp RZ series. The Zamp Z-20 visors are 3mm thick. All Z-20 visors also come with an anti-fog coating.

Speedwear a good choice!

  • Checkmark Top Quality
  • Checkmark Fast delivery
  • Checkmark Personal contact
  • Checkmark Personalization embroidery / printing
  • Checkmark Large stock in store/showroom
Pay safely
  • Visa Card
  • MasterCard
  • PayPal
  • KBC
  • Bancontact
  • Belfius
  • iDeal
  • And More

Description

ZAMP FIA Z20 visor Prism Blue

ZAMP FIA Z20 visor Prism Blue

The visors of the Zamp Z-20 series are designed to fit all helmets of the Zamp RZ series. The Zamp Z-20 visors are 3mm thick. All Z-20 visors also come with an anti-fog coating.

Zamp Z-20 visor replacement:

NOTE: It is important NOT to use power tools or overtighten the screws when replacing the visors.

  • Step 1: Lay a towel on a flat surface and place the helmet on it.
  • Step 2: Remove the pivot screws from each side of the shield. These are the smaller screws on the sides of the visor.
  • Step 3: Remove the pivot screws on both sides of the visor. This is the larger screw on the side of the shield. For best results, we recommend using a quarter to loosen/tighten these.
  • Step 4: Remove the visor. For best results, use a cloth to wipe the rubber seal and the area where the visor attaches to the helmet.
  • Step 5: Fit the new visor to the helmet. There are two white washers that go between the visor and the helmet, make sure they are in place before reattaching the visor.
  • Step 6: Screw the pivots (larger screw) into the visor by hand to hold the visor in place. Once they are hand-tightened, use a coin and tighten them until they fit snugly on the helmet shell. Do not over-tighten!
  • Step 7: Tighten the shield's tensioning screws by hand and tighten them to the desired tension for the visor's movement.

Additional Information

Weight 0.15 kg
Manufacturer